shout out to the go-fab team!
Posted: Thu Jun 06, 2019 10:20 pm
hey guys im new to the forum(as well as plasma cutting) - im down in Houston area- I am just getting my table up and going today 
I had sheetcam set to the wrong postprocessor so the tablet was freaking out! (it was in mach3) I set it to generic plasma (thanks ryan and dave) and its up and going -
time for some fine tuning and I think its time to BURN!!!!!
I had sheetcam set to the wrong postprocessor so the tablet was freaking out! (it was in mach3) I set it to generic plasma (thanks ryan and dave) and its up and going -time for some fine tuning and I think its time to BURN!!!!!