Correct settings

Post Reply
abzwardwell
Posts: 7
Joined: Mon May 13, 2019 6:31 pm
Correct settings

Post by abzwardwell » Tue Feb 04, 2020 9:39 pm

My plasma cutter will only go down to 30 amps
The line speed test from gofab crashes my tablet so I was wondering if any of you have settings for different thickness of material? I am tired of wasting metal conducting experiments trying to get good, clean, smooth cuts. The top is wider than the bottom on 3/8" plate and I have some 3/4" plate jobs to cut.

Thanks,

Arnold


Post Reply