Hello everyone! My name is Clif.

I've been saving to buy a CNC for a while now and am close to my goal. After A LOT of consideration and studying plus a few other factors I am convinced that I am in desperate need of a GoFab table.

I've owned several businesses throughout the years and have always done well. BUT! Being raised as I was I fight the demon of being a tight wad! BUT AGAIN! I do have a plan! ( And the Dahlia llama granted me eternal life. So I've got that going for me!)

I am looking forward to and can't wait to get my hands on a table. I've got years of blue prints that I've only been able to make one or two of. Hopefully others will like what I have. If not? I already have my van. Just need to find a river.

Good to meet you. It’s not crazy active here but your sense of humor tells me I want to see the stuff you’re making.

Good to meet you as well. The stuff I make now isn't too humourous just a lot of knuckle busting! Mostly car stuff. Every blue moon I do the odd ball project for friends and family. I almost had a truck sold the other day that would have put me over my goal for my table. But! It just didn't happen! So now I'm sitting in the driveway eating rocks. Oh well? I guess I can make it a little longer?

hang in there

I was in that boat a couple months ago but the vehicle sold and got my table yesterday. Going to garage now to start setting it up.