Hi! I bought machine this past September and I love it!
I am having an issue that I hope you guys can help me fix. I am using fusion 360 to write my G code.As of Jan 1 Fusion required that I upgrade my operating system to OS Mojave on my Mac. That alone is a pain in my ass! LOL
What’s going on is every since I have done the upgrade on my Mac any G code that I wright.... the tablet/ gofab does not recognize any pearse points.
I’ve tried rebooting the tablet rebooting my computer. I have gone into fusion 360 and look for Settings. I can take a G code that I created and simulate it... and it shows that it has pears points but once again the tablet will not recognize them.
I have simulated it on several different online sources… And it does show that it has pears points.
The tablet and table will run any G code that was created before the upgrade. So it’s not the table
I really don’t know where the problem lies, but I hope that someone else has run into this problem and you know how to fix it.
Do you have any ideas for this?
John

Did you get it sorted out? If you send me a simple gcode file that shows the issue I can take a look.