Using centers vs edges

Recommended by Go Fab CNC. This is a free program that's very powerful.
Post Reply
chademling94
Posts: 148
Joined: Sun Aug 19, 2018 6:57 pm
Location: Wisconsin
Using centers vs edges

Post by chademling94 » Sat Nov 17, 2018 4:17 pm

So when drawing a simple part such as a square pad with a hole in the center, is there a way to set a circle using the center of the circle apposed to the bottom left corner? I have always used centers for my drawings on paper so when i put that into inkscape i have to do another calculation to get the edge of the circle. Not a big deal just curious if there is a way to do that differently besides changing how i think about it lol
KROOKED IRON FAB & STEEL
CHAD EMLING
Millermatic 252
Synchrowave 210
Thermal Dynamics Cutmaster 52
Grizzly G0757Z H/V Mill
Grizzly G0765 Lathe
Ellis 1600
Everlast 80s
GoFab CNC 4'x8' Plasma Table


Post Reply