Getting Started with inkScape

Recommended by Go Fab CNC. This is a free program that's very powerful.
Post Reply
Go Fab CNC
Site Admin
Posts: 55
Joined: Fri Jun 22, 2018 1:03 pm
Getting Started with inkScape

Post by Go Fab CNC » Sun Nov 29, 2020 3:32 pm

Here a video showing how to setup inkScape to create GCode Files you can Cut on your Go Fab CNC Table.

This covers the most important part of the process that can also create the most confusion - picking the Folder where you want your GCode Files to be Saved!

Getting Started in inkScape


Post Reply