3/4"
-
- Posts: 148
- Joined: Sun Aug 19, 2018 6:57 pm
- Location: Wisconsin
3/4"
Pierces didn't go so hot (actually to hot ) but edge start worked good! I drilled a hole for the center pierce.
KROOKED IRON FAB & STEEL
CHAD EMLING
Millermatic 252
Synchrowave 210
Thermal Dynamics Cutmaster 52
Grizzly G0757Z H/V Mill
Grizzly G0765 Lathe
Ellis 1600
Everlast 80s
GoFab CNC 4'x8' Plasma Table
CHAD EMLING
Millermatic 252
Synchrowave 210
Thermal Dynamics Cutmaster 52
Grizzly G0757Z H/V Mill
Grizzly G0765 Lathe
Ellis 1600
Everlast 80s
GoFab CNC 4'x8' Plasma Table
-
- Posts: 148
- Joined: Sun Aug 19, 2018 6:57 pm
- Location: Wisconsin
Re: 3/4"
Yes 80 amp everlast. Cut at 65 amps and 175 feedrate
KROOKED IRON FAB & STEEL
CHAD EMLING
Millermatic 252
Synchrowave 210
Thermal Dynamics Cutmaster 52
Grizzly G0757Z H/V Mill
Grizzly G0765 Lathe
Ellis 1600
Everlast 80s
GoFab CNC 4'x8' Plasma Table
CHAD EMLING
Millermatic 252
Synchrowave 210
Thermal Dynamics Cutmaster 52
Grizzly G0757Z H/V Mill
Grizzly G0765 Lathe
Ellis 1600
Everlast 80s
GoFab CNC 4'x8' Plasma Table
-
- Posts: 148
- Joined: Sun Aug 19, 2018 6:57 pm
- Location: Wisconsin
Re: 3/4"
The way the torch is clamped is the issue. If you look in the Tips and Tricks section under (Cuts look jagged or sawtooth like) Bdspindles made a fantastic looking clamp which i think is the direction i am going to go. But yes anything over like 400mmpm i get a crazy torch jitter on sudden direction changes.
KROOKED IRON FAB & STEEL
CHAD EMLING
Millermatic 252
Synchrowave 210
Thermal Dynamics Cutmaster 52
Grizzly G0757Z H/V Mill
Grizzly G0765 Lathe
Ellis 1600
Everlast 80s
GoFab CNC 4'x8' Plasma Table
CHAD EMLING
Millermatic 252
Synchrowave 210
Thermal Dynamics Cutmaster 52
Grizzly G0757Z H/V Mill
Grizzly G0765 Lathe
Ellis 1600
Everlast 80s
GoFab CNC 4'x8' Plasma Table