Changing pierce point location

[MIPC&F]

Can anyone help with changing the location of the pierce points, I am trying to cut an American flag out and some of the stars have the pierce points coming from the outside and not the star that is the waste portion but a lot of them are ok as is. any help would be great I have only had this table for a few days and have already had pretty good results...

[Randy]

The only way i know how to do that is to go onto inkscape and fix the star i have that problem a lot where it's in the wrong spot and its a pain to go and do it all again

[MIPC&F]

Thanks Randy
I was thinking that was the only way also, but was hoping for a easier way I was not aware of....

[Randy]

I wish there was a easy way on the tablet