Accelerated Version 4.79 and UP Problems

[Go Fab CNC]

This is the place to post any issues you're experiencing with the newest release of the Go Fab CNC Accelerated Software Version 4.79.

We are actively monitoring this Forum and will roll out necessary changes ASAP.

[Yarbermarine& fab]

Unable to communicate with table

[Randy]

Keep your plasmas off well you update lol it will fire when updating table and then fire again when Finishing. Another is when you first load up you can't change size till you change out size of metal then you can change size. Other than that she is moving well no drag yet so that's good

[Colyevo]

THC still not working correctly, tips are new, good ground, but torch keeps raising after a couple of inches of cut! This has been an issue with all versions of software on my table!

It has also sporadically deleted a couple of separate files sent to table, after toggling with the settings a couple of times, when returning to cut, the file will be have disappeared!

[andrewt87]

Every time I try to verify my ignite or plunge height my app app crashes. Getting a constant pop up telling me to confirm my torch is installed correctly.

[chademling94]

Just tried the new 4.79 software. Updated fine and table moves around fine (ALOT FASTER) but when I try to bring in a file nothing shows up? It shows the amount of pierces and cut time but doesnt show the drawing on the screen, just says "tap to load file". I know they are good files, I have used them before the update and again after reverting to the old software just to make sure nothing weird happened.

[elopez]

Just tried the new 4.79 software. Updated fine and table moves around fine (ALOT FASTER) but when I try to bring in a file nothing shows up? It shows the amount of pierces and cut time but doesnt show the drawing on the screen, just says "tap to load file". I know they are good files, I have used them before the update and again after reverting to the old software just to make sure nothing weird happened.

Could you email me the file you're having issues with? eduardo@gofabcnc.com

[chademling94]

I'm out of the shop today but will right away tomorrow, the file isn't the issue, I've used them multiple times on the old software with no issues but I'll send it anyway just to make sure

[elopez]

I'm out of the shop today but will right away tomorrow, the file isn't the issue, I've used them multiple times on the old software with no issues but I'll send it anyway just to make sure

I'm sure the file isn't the issue, but it will allow me to see what part of the code in the app is crashing while opening the file

[chademling94]

Files are sent