Page 2 of 4
Re: Water Pans?
Posted: Sat Dec 08, 2018 1:08 am
by Diamondback
Leak tested...
Re: Water Pans?
Posted: Sat Dec 08, 2018 1:09 am
by Diamondback
Installed...
Re: Water Pans?
Posted: Sat Dec 08, 2018 1:11 am
by Diamondback
Circulation system (Big thanks to Dave!)...
Below is a repost of Dave's solution for fluid circulation.
https://drive.google.com/file/d/1nzgKAs ... 3uSwc/view
Re: Water Pans?
Posted: Sat Dec 08, 2018 1:12 am
by Diamondback
Filled up with 230 gallons and ready to cut...
Table solution (per 75 gallons)
1/4lb Sodium Nitrite
1 Teaspoon Physan 20
1oz. Green Food Dye
Re: Water Pans?
Posted: Sat Dec 08, 2018 1:26 am
by Diamondback
Re: Water Pans?
Posted: Mon Dec 10, 2018 1:38 pm
by contractcreativity
What does everyone do to retrieve smaller parts that fall through the slats?
Re: Water Pans?
Posted: Mon Dec 10, 2018 5:54 pm
by Dave
I go magnet fishing. With a high power flashlight.
Re: Water Pans?
Posted: Tue Dec 18, 2018 11:11 pm
by rdwesley
Where did you get your formula for the water? Does it work as well as the GreenCut fluid?
Re: Water Pans?
Posted: Wed Dec 19, 2018 12:20 am
by Diamondback
I got the recipe from this PlasmaSpider.com thread
https://www.plasmaspider.com/viewtopic.php?t=572
So far so good, no dust or smoke in the shop, no rust on my parts, couldn't ask for more.
Re: Water Pans?
Posted: Wed Dec 19, 2018 2:11 am
by Dave
I'm sure the homebrew stuff is fine. I strongly considered going with the homebrew version, but since I work out of an attached garage and have small kids, I wanted to be able to show Tamara the safety data sheet