Re: Water Pans?
Posted: Sat Dec 08, 2018 1:08 am
Leak tested...
A community for current and future Go Fab CNC Plasma Table owners
https://gofabcnc.com/forum/
Water Pans?
Page 2 of 4
Re: Water Pans?
Posted: Sat Dec 08, 2018 1:09 am
Installed...
Re: Water Pans?
Posted: Sat Dec 08, 2018 1:11 am
Circulation system (Big thanks to Dave!)...
Below is a repost of Dave's solution for fluid circulation.
https://drive.google.com/file/d/1nzgKAs ... 3uSwc/view
Below is a repost of Dave's solution for fluid circulation.
https://drive.google.com/file/d/1nzgKAs ... 3uSwc/view
Re: Water Pans?
Posted: Sat Dec 08, 2018 1:12 am
Filled up with 230 gallons and ready to cut...
Table solution (per 75 gallons)
1/4lb Sodium Nitrite
1 Teaspoon Physan 20
1oz. Green Food Dye
Table solution (per 75 gallons)
1/4lb Sodium Nitrite
1 Teaspoon Physan 20
1oz. Green Food Dye
Re: Water Pans?
Posted: Sat Dec 08, 2018 1:26 am
Video coming shortly...
https://www.youtube.com/watch?v=E-hsij87ScQ
https://www.youtube.com/watch?v=E-hsij87ScQ
Re: Water Pans?
Posted: Mon Dec 10, 2018 1:38 pm
What does everyone do to retrieve smaller parts that fall through the slats?
Re: Water Pans?
Posted: Mon Dec 10, 2018 5:54 pm
I go magnet fishing. With a high power flashlight.
Re: Water Pans?
Posted: Tue Dec 18, 2018 11:11 pm
Where did you get your formula for the water? Does it work as well as the GreenCut fluid?
Re: Water Pans?
Posted: Wed Dec 19, 2018 12:20 am
I got the recipe from this PlasmaSpider.com thread https://www.plasmaspider.com/viewtopic.php?t=572
So far so good, no dust or smoke in the shop, no rust on my parts, couldn't ask for more.
So far so good, no dust or smoke in the shop, no rust on my parts, couldn't ask for more.
Re: Water Pans?
Posted: Wed Dec 19, 2018 2:11 am
I'm sure the homebrew stuff is fine. I strongly considered going with the homebrew version, but since I work out of an attached garage and have small kids, I wanted to be able to show Tamara the safety data sheet 