Submerged cuts?
Submerged cuts?
Wanting to find out who submerged their metal to cut in a water table and if there are any advantages to doing so? GreenCut recommends it. I personally haven’t tried but I think I might. Wanting to know others experience with this.
-
- Posts: 148
- Joined: Sun Aug 19, 2018 6:57 pm
- Location: Wisconsin
Re: Submerged cuts?
I have mine right up to the backside of the plate but I'm also curious about completely submerging it. The edges of my water pan would allow me to cut 11 ga about 3/4" under water but don't know how that will go lol
KROOKED IRON FAB & STEEL
CHAD EMLING
Millermatic 252
Synchrowave 210
Thermal Dynamics Cutmaster 52
Grizzly G0757Z H/V Mill
Grizzly G0765 Lathe
Ellis 1600
Everlast 80s
GoFab CNC 4'x8' Plasma Table
CHAD EMLING
Millermatic 252
Synchrowave 210
Thermal Dynamics Cutmaster 52
Grizzly G0757Z H/V Mill
Grizzly G0765 Lathe
Ellis 1600
Everlast 80s
GoFab CNC 4'x8' Plasma Table
-
- Posts: 148
- Joined: Sun Aug 19, 2018 6:57 pm
- Location: Wisconsin
Re: Submerged cuts?
Cut last night with the water 1/8" over my plate and it cuts amazing!! Top side is perfect crisp lines and almost no dross on the backside! Used to have to rip dross off with 36 grit wheel now I just buzz it with a 120 grit and its minty!
KROOKED IRON FAB & STEEL
CHAD EMLING
Millermatic 252
Synchrowave 210
Thermal Dynamics Cutmaster 52
Grizzly G0757Z H/V Mill
Grizzly G0765 Lathe
Ellis 1600
Everlast 80s
GoFab CNC 4'x8' Plasma Table
CHAD EMLING
Millermatic 252
Synchrowave 210
Thermal Dynamics Cutmaster 52
Grizzly G0757Z H/V Mill
Grizzly G0765 Lathe
Ellis 1600
Everlast 80s
GoFab CNC 4'x8' Plasma Table