Page 1 of 2

Reviews

Posted: Sat Jul 14, 2018 11:26 pm
by Lairdfab
Hey there, I’m looking at purchasing the 4x8 table with the 60amp plasma, and was looking for some reviews on the GoFab table. Please share how your experience with this product has been. Thanks

Re: Reviews

Posted: Fri Nov 02, 2018 9:56 pm
by rdwesley
I have had my table about 2 months now, and absolutely love it. Ryan and Sam are always on top of things, and act quickly when there is an issue. I don't think you will be disappointed at all.

Re: Reviews

Posted: Sun Nov 04, 2018 7:28 pm
by Midwestcoastfab
I’ve had my table for about a month. So far it has given me the capability to pay for almost half of it. It took about a good three hours for me to really figure out how it works. Ryan and Sam definitely has their shit together. I have had two issues so far with the table. Both of them were fixed within hours. I have one issue with ink scape that I can’t seem to figure out. It only happens on this run design. So I’m going to play with it a little bit more and see what I can come up with. So everything with the table has been amazing. I would personally recommend going to Texas to pick it up. My only reasoning for that is because it made the learning curve a lot easier. I am by no means a CNC operator and my professional or personal life. The ease of the machine allowed me to jump right in and get shit done immediately. Way easier than our set up that we have at my work.

Re: Reviews

Posted: Thu Mar 12, 2020 6:13 pm
by dirtpig
I like the table. Software takes some time to get familiar with. Hard to get any support.

Re: Reviews

Posted: Fri Mar 13, 2020 11:45 pm
by Jon
It’s hard to get any support

Re: Reviews

Posted: Sat Mar 14, 2020 4:41 pm
by Cowley62
Same as above no support an no manuals

Re: Reviews

Posted: Sat Mar 14, 2020 7:25 pm
by john swisher
It's a shame because the table when it work it does a good job. Just if you have a problem no one helps. Most of the help comes from the forum. Thank you to the people on the forum

Re: Reviews

Posted: Sat Mar 14, 2020 9:22 pm
by Jon
Is gofab still in business?

Re: Reviews

Posted: Tue Mar 31, 2020 1:09 am
by plasmaman
Anybody find out if GoFab is still in business? They got my deposit on a new table two months ago and now they will not reply to me. Beginning to think I just got screwed.

Re: Reviews

Posted: Tue Mar 31, 2020 2:14 pm
by chademling94
They are still going as far as I know. Elopez (tech guy) is still active on the forum and GOFABCNC just posted the other day.