Hand torch

Post Reply
Midwestcoastfab
Posts: 102
Joined: Mon Jul 30, 2018 1:20 am
Hand torch

Post by Midwestcoastfab » Fri Oct 11, 2019 5:29 pm

I just bought a hand torch and the people at everlast we’re no help. Do I need to change any settings to use my hand torch?

Ryan Lindsey
Posts: 64
Joined: Thu Jun 28, 2018 4:21 am
Re: Hand torch

Post by Ryan Lindsey » Fri Oct 11, 2019 7:52 pm

You shouldn’t need to. The Handheld and CNC Torch are the same design, just a different body. You can leave everything hooked up like you’re using the Table and just swap the Torches and start cutting Handheld.

Midwestcoastfab
Posts: 102
Joined: Mon Jul 30, 2018 1:20 am
Re: Hand torch

Post by Midwestcoastfab » Sun Oct 13, 2019 7:51 pm

Awesome! Thanks man. Wasn’t sure if I should disconnect the Cnc port or anything


Post Reply