Search found 98 matches
- Mon Jan 28, 2019 1:54 am
- Forum: Share your Work!
- Topic: Knife Blanks
- Replies: 2
- Views: 6064
Re: Knife Blanks
I can't take much credit on this one. Customer supplied the .svg and the steel, pretty much all I did was line it up on the table and press play.
- Mon Jan 28, 2019 1:29 am
- Forum: Share your Work!
- Topic: Knife Blanks
- Replies: 2
- Views: 6064
Knife Blanks
Apparently plasma is a good choice for knife blanks since the heat affected zone gets ground off and the blades are heat treated during finishing. This was 1/8” 80crv2. I gave the customer a discount for leaving the slag on since it was less work for me and no difference for him. Another customer to...
- Thu Jan 24, 2019 6:48 pm
- Forum: Water Pans
- Topic: Water Pans?
- Replies: 31
- Views: 51126
Re: Water Pans?
With GreenCut you just use litmus paper to check ph. If it's too high, add water, if it's too low, add GreenCut. I'd imagine the same would be true for the solution Diamondback posted since water evaporation will just increase the concentration of sodium nitrite, making the solution more basic (add ...
- Wed Jan 02, 2019 2:51 pm
- Forum: Share your Work!
- Topic: Firepit From 4x5 10 gauge
- Replies: 7
- Views: 13721
Re: Firepit From 4x5 10 gauge
Love the 100 yard grill. I might experiment with clip together.
- Mon Dec 24, 2018 4:39 am
- Forum: Share your Work!
- Topic: Harley Davidson cut out.
- Replies: 4
- Views: 8487
Re: Harley Davidson cut out.
Is there a specific set of steps that always results in those lines showing up? I’m trying to bullet proof some parts of the tablet against slightly malformed but mostly OK gcode.
- Sat Dec 22, 2018 10:05 pm
- Forum: Share your Work!
- Topic: Another Firepit
- Replies: 4
- Views: 7940
Re: Another Firepit
I’m using 10 gauge, but generally if I find myself burning through consumables on thicker stuff, backing off the ignite/plunge/cut height tends to help. On 1/2” the steel was spraying back up and grabbing the tip while piercing.
- Thu Dec 20, 2018 2:12 pm
- Forum: Share your Work!
- Topic: Another Firepit
- Replies: 4
- Views: 7940
Re: Another Firepit
More...
- Thu Dec 20, 2018 2:07 pm
- Forum: Share your Work!
- Topic: Another Firepit
- Replies: 4
- Views: 7940
Another Firepit
Apparently Jeep themed pits are in demand
- Wed Dec 19, 2018 2:11 am
- Forum: Water Pans
- Topic: Water Pans?
- Replies: 31
- Views: 51126
Re: Water Pans?
I'm sure the homebrew stuff is fine. I strongly considered going with the homebrew version, but since I work out of an attached garage and have small kids, I wanted to be able to show Tamara the safety data sheet
- Sun Dec 16, 2018 4:19 am
- Forum: Share your Work!
- Topic: Saturday night
- Replies: 2
- Views: 6019
Re: Saturday night
Glad you got bailed out. If you check out the new gofabcnc.com home page, you might notice some changes. Hmm....