If you purchase our complete package, you won't need to purchase anything else to start cutting on your machine.
- You will need to choose a program for designing parts to cut (ex: InkScape, SolidWorks, SheetCAM, etc.)
POWER REQUIREMENTS
Go Fab CNC Table and All Electronics
- Standard 110v
Go Fab CNC PowerEdge 80 Plasma Cutter
- Standard 220v Single Phase
- 80 Amp Breaker
MEGA 60 Gallon Compressor
- Standard 220v Single Phase
- 20 Amp Breaker
PLASMA REQUIREMENTS
Our system is compatible with any plasma cutter that has a CNC port. To use the Automatic Torch Height Control, the plasma cutter must provide access to the cutting voltage (usually accessed through the CNC port, though some Thermal Dynamics require additional wiring).
COMPRESSOR REQUIREMENTS
Compressor requirements are determined by the plasma cutter being used. If you use the Go Fab CNC PowerEdge 80 that we offer, then you'll need a compressor capable of providing 5.5 cfm at 90 psi. We run our compressor at 75psi. The larger the compressor tank, the less often the compressor motor will need to run.